[r4f4w]

I've installed XanMod this morning and I have noticed that my server var are worst.

With only tuned performance, I was getting between 0.009 and 0.005, but now, my var it's going crazy! Jumping very quickly between 0.013 and 0.008!

I know, this isn't a bad var, but with XanMod, var is no longer stable as it was before.

I just installed via terminal and since then I haven't done any other configuration.

Is that something in XanMod that I have to setup?

Do I have to activate tuned perfomance again?

[ThePwnt]

tuned-adm profile latency-performance =)

//What CPU are you using? and how many slots?

[r4f4w]

Originally Posted by ThePwnt tuned-adm profile latency-performance =) //What CPU are you using? and how many slots?

I'm using a Intel(R) Core(TM) i7-6700 CPU @ 3.40GHz

I have 9 servers with 10 slots each and one of them with 16 slots. All 128 tick.

[r4f4w]

Originally Posted by ThePwnt tuned-adm profile latency-performance =) //What CPU are you using? and how many slots?

I've already have tuned, and it works very well, but with xan mod everthing is worst.

[Mikado]

I've used it at a time, but since the last update the perfomances gone worst, try something else like Liquorix or an old compatible kernel.
Or simply to avoid problems use default on with tuned, it works great ;)

[r4f4w]

Originally Posted by Mikado I've used it at a time, but since the last update the perfomances gone worst, try something else like Liquorix or an old compatible kernel. Or simply to avoid problems use default on with tuned, it works great ;)

Yes, I've reinstalled Debian, to a clean new fresh install, and just installed tuned. Now everthing is great!

To everyone that is reading and thinking to install, keep in mind that XanMod isn't great for some users.

[maxee]

I personally can recommend Liquorix - been using it ever since and it provides the best performance I've had.

The var on our servers (10+, 12 slots each, 128-tick) stays at 0.001-0.005(at max!) at all time.

//E: The CPU we use is a Ryzen 5 3600.

[mariozankl]

I also have problems with the lastest XanMod Kernel on Debian 10. How can i go back to the default kernel?

[ThePwnt]

Originally Posted by mariozankl I also have problems with the lastest XanMod Kernel on Debian 10. How can i go back to the default kernel?

What does it show of kernels, if you are using:

update-grub2

[Maxximou5]

If you're willing to take the time you could change the kernel hertz from the default 500 which XanMod uses to 1000hz and compile your own.
https://github.com/xanmod/linux/blob/5.6/.config#L498