[aligind4h0us3]

Server Type: Dedicated
Operating System: Debian 64Bit
Version of UAIO: UAIO v1.51
Command: uaio_menu > Good Commands > Seer Mode.
Description: Whilst testing this command, I found it very buggy as half the time the lines did not point to an enemy, but rather into thin air. A good example of a working Seer Mode would be the UWC3 rune, Seer. If you could get the data from that and edit it to fit in, it would be good as it is not buggy at all and is very accurate.

[Particlman]

unless they are close enough then it displays their last known posistion

[aligind4h0us3]

That can't be right, I have seen many instances where it points to where an enemy could not possibly be, or get to.

[Xanimos]

This points through the wall at people. Do you see the line going into a wall or something?

[aligind4h0us3]

I know what it does and I know what it is supposed to do. There are multiple lines pointing to no enemy and there are some lines that do. Go into an UWC3 server with runes and look at the seer rune. That is what it should be like. Unfortunately, this seer mode picks up lines going to nowhere, and to no one. Half the time not even in the direction of the enemy.

[aligind4h0us3]

Sometimes the line doesn't go through a wall or even touch a wall, there is definately something buggy with it.

[aligind4h0us3]

Have you looked into this at all?

[aligind4h0us3]

Join one of our servers and I will give you Seer Mode and you can see for yourself.

[counterclock]

It works on my server not buggy at all

[aligind4h0us3]

It must be cause we on amd 64