rates
 

i try http://www.reece-eu.net/drekrates.php
but they didnt fix their cores so im asking if someone can give me right rates for my server here is my box performance:
8 GB Ram
32 slots
100 MBPS
Quad-Core AMD Opteron(tm) Processor 2376 2.5Ghz

Re: rates
 

The amount of cores is not important as HLDS only uses 1 at any given time anyways.

Re: Need help determining your rates? Look Here
 

sv_minrate 0
sv_maxrate 371094
sv_minupdaterate 4
sv_maxupdaterate 1237
thats what i got so u think its correct?

Re: Need help determining your rates? Look Here
 

All these rates calculators gives crappy values for modern internet connections. For example, sv_maxrate over 20000 is useless, because hlds limits it to 20000.

For first time, try these:
sv_maxupdaterate depends on kind of your server. 60 Should be enough for meatservers running Gungame or ZP mod. If you want to get better performance, set it to 101.

It was the first step.

The second step is to adjust rates to your server's bandwidth. You should play on server with active netgraph (net_graph 3) and monitor choke value - it should not get higher than 5-10. If you have a lot of choke, you should increase sv_minrate. Also, don't forget that you will get effect of server-side rates changing only after reconnect.

rates configuration server 32 slots
 

Commands are the rates to maintain a server of 32 slots with a low and stable ping?

Re: rates configuration server 32 slots
 

check this:
http://www.reece-eu.net/drekrates.php

Re: rates configuration server 32 slots
 

SEARCH BEFORE YOU POST :rtfm:

Re: rates configuration server 32 slots
 

May be this will help you...
http://amxmodxbg.org/forum/viewtopic.php?t=13558

The perfect rates
 

From Speedtest.net, this is my result:
Download 8.64Mb/s
Upload 0.72Mb/s

Can someone help me determine the best possible rates for me? I run a 16 man server.

Also, help me determine the best possible fps_max & sys_ticrate. I run Pentium D 3.00GHz and have 4.00GB of RAM.

Re: The perfect rates
 

Well from the Sticky Post, I got the link for rate Calculation HERE. Accroding to the Config Given by You I used:

Up Speed: 735 kbps/sec
CPU Speed: 3000 Mhz Core: 1 (Not Necessary)
Ram: 4096 MB
Players:16

What I got was:

sv_minrate 0
sv_maxrate 5453
sv_minupdaterate 4
sv_maxupdaterate 18

I would advice you to use sys_ticrate 100 and fps_max 101 (1 higher to sys_ticrate).:wink:

Well You can look yourselves too or wait for other good replies.